Details, Details, Details!
Front Fender, Brake Pedal and Kickstand

Using the same trailer fenders I used to make the rear fender, I did the same trick I had done before, but this time it was the right radius.

I cut the front edge back and marked for the rear cut...

Done!

Welded some blocks to the forks, added some flanges to the fender and bolted it on!

The brake pedal... I also added some eyelets to hold the cable housing.

Cable routed and hooked to the caliper.

Oh yeah... The seat is finished. Obviously I don't do leather too good.

This is where my ass goes.

Here's the general idea for the kickstand.

I had to move the stop bolt to the kickstand side, cuz I screwed up.

Now I have a bonus hole on the shaft housing...

Voila... The stand in the kicked position.

...and in the road ready position.

The spring to hold the kickstand up.

Back to the main page